46
edits
Changes
Jump to navigation
Jump to search
Initial entry for MIMO section. Possible extras requirements needed for FTDI cable, programming cable.
<b>The WiFi module has a limited transfer rate. The maximum possible frame update rate is about 10 Hz when using the WiFi connection.</b>
= SiRad MIMO =
Requirements:
*MS Windows 7/10
*ST-LINK USB driver (STSW-LINK009)[http://www.st.com/content/st_com/en/products/embedded-software/development-tool-software/stsw-link009.html]
*Software Package by Silicon Radar
*5V Barrel Jack Power Supply (5.5mm)
*Ethernet Connection & Cable
<b>DHCP Connection to PC:</b>
The Evaluation Kit interfaces with the PC through an Ethernet connection. This connection is managed by a DHCP protocol.
Connect the 5V power supply to the kit. Once successfully powered, LED D2 located near the SD card should blink green for a few seconds indicating that linux is successfully booting from the SD card.
== DHCP Connection to PC - Possibility One - Kit as Client ==
On startup, the kit will search for a DHCP server to become a client of. Once the kit is subscribed to the DHCP server, any client running the GUI will be able to connect to it and run the Kit.
== DHCP Connection to PC - Possibility One - Kit as Server ==
If there is no DHCP server present, the kit will time out searching for the server after approximately 60 seconds and become a DHCP server itself. Once this happens any client connected to the kit (i.e. a user PC) will be assigned an IP address by the kit and will be able to connect to and run the kit via. the GUI.
